Table of Contents
Advertisement
3. (For a parallel system) On the MDU of the master cabinet, choose System Info > Settings >
Basic Param, and set Transformer Cabinet SPD Fault Alm. Cond. to Close.
Setting Parameters for the Lithium Battery Cabinet
7.4
Default User
admin (administrator)
Operator (common user)
1. Set the language, time, date, network parameters, and system parameters on the Settings
Wizard screen.
Parameter
Module battery LVD
voltage
EPO enable
Powering On Loads
7.5
Turn the output disconnector of the isolation transformer to ON.
Tap the start/stop button
control the system output. Wait about 4 to 5 minutes until the load starts to
LCD Preset Password
000001
000001
Setting
If the voltage of a single battery module is lower than the value of this parameter,
the battery module is automatically powered off. Set this parameter based on site
requirements.
To enable the EPO function, set this parameter to Enable.
Turn the AC output circuit breaker in the ICC cabinet to ON.
WebUI Preset Password
Changeme
Changeme
on the MDU main menu of the ICC cabinet to
power on.
23
Advertisement
Table of Contents
