Table of Contents
Advertisement
1. Set the language, time, date, network parameters, and system parameters on the Settings
Wizard screen.
Parameter
EPO detection
Lihv battery equip IP
2. Set communications parameters for other devices on the MDU of the master cabinet.
Path
Parameter
Monitor Parallel IP (for a
parallel system)
System Info >
Lihv Battery Equip IP
Settings >
NetEco Primary IP
Communication
NetEcoPort Number
Setting
EPO (emergency power-off) is performed only when this parameter is
enabled and the EPO switch is triggered. When EPO detection is changed
from Disable to Enable, check that the EPO cable is connected correctly.
The IP address of the lithium battery cabinet must be the same as the lithium
battery cabinet IP address set for the ICC cabinet.
The IP address of the lithium battery
cabinet must be the same as the
lithium battery cabinet IP address set
for the ICC cabinet.
Setting
IP address of the slave cabinet
IP address of the lithium battery cabinet
Set this parameter according to the address
information provided by the network administrator.
Set this parameter as required.
22
Advertisement
Table of Contents
