Positioning And Orientation Of Eva With Magne 4 - ABB Magne 3 Product Manual

Make sure the surfaces of the electromagnet (A) and the anchor plate (B) are completely
parallel, i.e. that full contact is obtained when the door is closed. If ABB mounting accessories
are not used, make sure the anchor plate cannot rotate. If the anchor plate tilts, the holding
force of the lock can be significantly reduced or eliminated.
X
Installation tolerances between Magne and anchor plate:
Ref Part
A Magne electromagnet
B Anchor plate
Note! To achieve maximum holding force the anchor plate must be installed completely
parallel to Magne.
4.3.5

Positioning and orientation of Eva with Magne 4

The safety functionality of Magne 4 is based on the integrated Adam sensor and the Eva
actuator.
Eva unit (A) must be correctly positioned above the yellow cover on Magne/Adam (B) when
the door is closed.
Note! For the sensor to work as intended it is very important that the units are correctly
positioned and that the safety functions are tested.
Positioning tolerances for Eva and integrated Adam in Magne 4:
Ref Part
A Eva
B Adam
2TLC172315M0201 Rev.M3
Y
Ref
X
Y
Ref Distance
X ±5 mm sideways
Y ±5 mm lengthways
Z 2-7 mm
Distance
±3 mm sideways
±5 mm lengthways
1 4