Advertisement
3.3.
Tyre fitting
3.3.1
Lubricate both tyre beads with an approved rubber lubricant.
3.3.2
Mount and lock the wheel to the stand.
3.3.3
Place the lower bead of the tyre over the wheel rim (fig.5) and insert the fitting head of the tyre bar between the bead and the rim
with the bead on the ledge of the fitting head (fig.6).
3.3.4
Lever the bar against the wheel location clamp and rotate the bead over the rim (fig.6).
3.3.5
fit an inner tube if appropriate and then seat the upper bead in the same manner (fig.7).
3.3.6
Attach an air line gauge to inflate the tyre to seal the beads against the rim (fig.8), remove the air line gauge and refit the tyre valve
core. Adjust the tyre pressure to the manufacturers recommended pressure.
WARNING! check that the bead has fully sealed against the wheel rim before replacing the valve core.
3.3.7
Remove the lock nut and remove the wheel from the tyre changer.
fig.1
fig.4
fig.7
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
fig.2
fig.5
fig.8
Sole U.K. Distributor
Sealey Group
Bury st. Edmunds
suffolk.
fig.3
fig.6
01284 757500
Web
01284 703534
e-mail
www.sealey.co.uk
sales@sealey.co.uk
Tc967
Issue no: 1 - 21/10/08
Advertisement
