Sealey TC968.V2 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
‰
equipment. Under Health and Safety Law, Employers and Self Employed Personnel have a legal duty to ensure Safe Working
Conditions for all employees and personnel that may come into contact with this equipment. In particular they must carry out a specific
risk and hazard assessment in the workplace to eliminate or reduce any risk found and must record, update and retain records of the
results of this inspection.
Familiarise yourself with the applications, limitations and any possible or potential hazards of the bead breaker.
9
maintain the bead breaker in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
WARNING! Check regularly for damaged parts. Any part that is damaged must be repaired or replaced before the equipment is next
‰
used.
Locate the bead breaker in a suitable work area, keep area clean and tidy and free from unrelated materials. Ensure that there is
9
adequate lighting.
Keep the bead breaker clean for best and safest performance.
9
Wear approved safety eye protection and gloves.
9
Keep hands well clear of the bead breaker.
9
maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip safety shoes.
9
Remove ill fitting clothing. Remove ties, watches, rings other loose jewellery and contain and/or tie back long hair.
9
Keep children and unauthorised persons away from the work area.
9
DO NOT use the bead breaker for any purpose other than that for which it is designed.
8
DO NOT operate the bead breaker if any parts are damaged or missing as this may cause failure and/or personal injury.
8
DO NOT allow untrained persons to operate the bead breaker.
8
DO NOT stand on the bead breaker.
8
DO NOT operate the bead breaker when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
2. INTRODuCTION
manual bead breaker especially suitable for motorcycle tyres. Lever action with parallel linkage keeps head at the optimum angle for breaking
the bead.
3. SpECIFICATION
model no ................................................................ TC968.V2
Weight ........................................................................... 4.6kg
max. bead thickness .................................................. 160mm
max. tyre profile ......................................................... 190mm
4. OpERATION
4.1. BEAD BREAKING
4.1.1. Deflate the tyre by removing the valve core.
4.1.2. Align the shoe of the bead breaker so that it sits on the tyre and close to
the edge of the wheel rim.
4.1.3. Apply firm pressure to the bead breaker by pushing down on the long
handle, gradually work around the wheel rim until the bead has
separated from the rim.
4.1.4. Turn wheel over and repeat to free the other bead.
© Jack Sealey Limited
TYRE BEAD BREAKER
mODEL NO:
Wear
protective
gloves
Original Language Version
TC968.V2
TC968.V2 | Issue:1 10/01/19