Mitsubishi Electric BAC-HD150 Instruction Book page 39

(4) Data setting
Make the setting for the BAC-HD150 system and BACnet
The following table shows setting items. (Refer to the Instruction Book that came with Setting Tool for setting method.)
No.
1
2
3
4
5
6
7
8
9
10
11
When BAC-HD150 is connected to PAC-YG50ECA, the settings of the M-NET address, group, and interlocked operation with
LOSSNAY are made by using AG-150A. It is not necessary to make these settings on BAC-HD150.
CAUTION
If IP address of BAC-HD150 overlaps any of the addresses that are assigned to other devices, communications
cannot be performed properly via BAC-HD150 or other devices. Check the address before setting.
MEMO :
When settings are changed by using Setting Tool after the initial settings have been completed, it is not necessary
to disconnect the LAN1 cable from BACnet
Main tab
Basic System
System Settings M-NET
Expansion Controller
Group
Group Settings
LOSSNAY
BACnet
Network and Device
COV Notification
®
BACnet Settings
Event Notification
Object
Other
®
®
related items by using Setting Tool.
Sub tab
All setting items
No settings required
Access Point Settings
No settings required
No settings required
®
All setting items
All setting items
All setting items
All setting items
All setting items
All setting items
and the LAN2 cable from HUB1.
- 39 -
Setting item