Using The Seed Cover; During Operation; During Operation Safety - Toro 23508 Operator's Manual

Using the Seed Cover

•
To install the seed cover
the seed hopper and fasten it to the latch posts on
either side using the rubber latches.
•
To remove the seed cover, pull each rubber latch
down and away from the latch posts and remove
the cover.
1. Seed cover
2. Seed hopper
(Figure 11), place it over
Figure 11
3. Rubber latch
4. Latch post

During Operation

During Operation Safety

General Safety
•
The owner/user can prevent and is responsible
for accidents or injuries occurring to people, or
damage to property.
•
Wear appropriate clothing, including eye
protection; long pants; slip-resistant, substantial
footwear; and hearing protection. Tie back long
hair and do not wear loose jewelry.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Never carry passengers on the machine and keep
bystanders and pets away from the machine
g024773
during operation.
•
Operate the machine only in good visibility to avoid
holes or hidden hazards.
•
Avoid operating the machine on wet grass.
Reduced traction could cause the machine to slide.
•
Ensure that all drives are in neutral, the parking
brake is engaged, and you are in the operating
position before you start the engine.
•
Keep your hands and feet away from the blade
area.
•
Look behind and down before backing up to be
sure of a clear path.
•
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure your
vision.
•
Stop the blades whenever you are not operating
the machine.
•
Stop the machine, shut off the engine, engage the
parking brake, and inspect the blades after striking
an object or if there is an abnormal vibration in
the machine. Make all necessary repairs before
resuming operation.
•
Slow down and use caution when making turns
and crossing roads and sidewalks with the
machine. Always yield the right-of-way.
•
Shut off the engine, and disengage the cutting
blades before adjusting the cutting-blade depth.
•
Never run an engine in an area where exhaust
gases are enclosed.
•
Never leave a running machine unattended.
•
Before leaving the operating position for any
reason, do the following:
14