Siemens SIMOTION D4x5-2 DP/PN Operating Instructions Manual page 113

The following figure shows an example of the variant with a PROFINET connection to the
camera measuring system. If the UDP protocol is used, it is configured via Ethernet and the
MV440 in the HW Config of the SIMOTION is not required [Ref. 1].
Figure 5-4
The specified IP addresses are not fixed and can be changed as required.
SC integrated STS, GSU
Operating Instructions, 07/2019, A5E48271265B AA
SIMOTION D4x5-2 DP/PN hardware configuration
Configuration
5.5 PROFINET configuration
113