Indicator - Huawei Box 700 Product Overview

HUAWEI Box 700
Product Overview
Category

4.3 Indicator

By checking the status of the indicator on a Box 700, you can determine its operating status
and ensure that it is working properly with other videoconferencing devices.
Table 4-3
Issue 05 (2019-06-20)
No. Component
16 COM port (dual-mode
serial communication
port)
17 Ethernet ports (LAN1:
primary network port
used for external
services; LAN2: backup
network port used for
transparent transmission
and internal
management)
18 RESET button
19 Power input port
(100-240 V AC, 50/60
Hz, 3 A)
20 Ground stud
21 Power switch
shows the Box 700 status corresponding to each indicator status.
Copyright © Huawei Technologies Co., Ltd.
Function
Connects to a camera control cable for
camera control and infrared transmission.
It can also be used for fault diagnosis and
maintenance of the Box 700.
A camera connected to the Box 700 can
be upgraded through this port or the HD-
VI port.
l 10/100/1000 Mbit/s full duplex and
half duplex
l Transparent transmission at the IP
layer
l During startup, press and hold this
button for 10s to restore the A/B
system.
l When the Box 700 is running, press
and hold this button for 10s to reset it
to factory settings.
After you press and hold this button
for 5s, the system will display a
prompt indicating that your Box 700
will be reset to factory settings if you
press and hold this button for 10s.
Connects to a power supply.
Connects to a ground cable.
Powers the Box 700 on or off.
NOTE
Connect all necessary cables before powering
on the Box 700.
4 Product Structure
11