Interlinking Your Smoke Alarms - FireAngel THERMOPTEK Wi-Safe 2 User Manual

2. Install Base Plate
Fit the base plate to the ceiling or wall using
the screws provided.
3. Fit Your FireAngel Smoke Alarm
To fit to the smoke alarm to the base plate
included in this pack, position the alarm on
the base plate then twist it clockwise until
the alarm is locked in position. Make sure the
alarm is twisted on fully.
The battery will now activate. The red
indicator LED on the front of the alarm
should flash approximately once every
45 seconds to show that the alarm is active.
WARNING: Removing the smoke alarm
from its base plate will deactivate the unit
and prevent it from detecting smoke.
6
4. Test Your FireAngel smoke alarm
After fitting the alarm to the base plate, wait
for 5 seconds for the alarm to settle, then test
the alarm. See "Alarm Test" .
INTERLINKING YOUR
SMOKE ALARMS
The W2-Module in your ST-632 enables you
to wirelessly interlink with other alarms with a
W2-Module and create a Wi-Safe 2 network.
In order to communicate with each other,
W2-Module enabled alarms need to be "learned
in" or interlinked. If one alarm activates, all
other interlinked smoke alarms will also sound.
Note that Wi-Safe 2 smoke alarms can only be
interlinked with other Wi-Safe 2 smoke alarms
and other products within the Wi-Safe 2 range.
"Learning in" (interlinking) your Smoke
Alarms:
The process below describes 'learning in'
two alarms into a network,
"Alarm 2".
1. Alarm 1: Install Alarm 1 as described
previously.
2. Alarm 2: Install the base plate for Alarm 2
in one of the recommended locations. Do
not fit the second alarm to its base plate
yet.
3. Alarm 2: Using a pen, a paper clip that has
been opened out, briefly push and release
the learn button located in a circular hole in
the back of Alarm 2.
"Alarm 1" and