Related Manuals for FireAngel Thermoptek ST-632
Summary of Contents for FireAngel Thermoptek ST-632
- Page 1 User Manual 10 Year Life Multi Sensor Smoke Alarm ST-632 TEST YOUR ALARM MONTHLY Please retain this user manual for future reference...
-
Page 2: Table Of Contents
Note: This User Manual is also available in large text and other formats Please call 0330 094 5830 for further information ST-632 GN5490R1 FireAngel Safety Technology Limited Vanguard Centre, Coventry CV4 7EZ UK www.fireangeltech.com Technical Support: 0330 094 5830 / EIRE dial 1-800 523171 Email: specification@fireangeltech.com... -
Page 3: Introduction
Smart This combines an optical sensing chamber RF Module which operates on FireAngel’s with thermal enhancement. The alarm is Wi-Safe 2 networking protocol. effective at detecting slow burning fires, and... - Page 4 WARNING: The alarm positions shown Your smoke alarm typically meets the minimum requirements for family living are based on typical homes. Construction units in existing buildings, as long as at least and layout of individual dwellings will one unit is installed on each floor/level of vary, so this should be regarded only as a your property.
-
Page 5: How To Install Your Smoke Alarm
HOW TO INSTALL YOUR already be a primary fire detection system that meets regulatory requirements for SMOKE ALARM common areas such as lobbies and hallways. IMPORTANT: Make sure you have read and Institutions and Hotels understood this manual before installing This includes motels, hospitals, day care your smoke alarm. -
Page 6: Operation
ALARM CONDITION If your FireAngel alarm goes into alarm, 3 loud beeps will sound, which continually repeat until the cause of the alarm being activated is found and resolved. The red LED on the alarm will flash rapidly (once per second) during these alarms. - Page 7 IMPORTANT: Your smoke alarm requires that its battery has sufficient power capacity to operate correctly. Should your FireAngel smoke alarm enter a low battery condition, the unit will emit an audible ‘chirp’ once every 45 seconds and the amber LED will flash at around the same time.
-
Page 8: Led Indicators
Sensitivity will return to secs for up has reduced normal within 10 mins to 10 mins sensitivity Call FireAngel technical Flashes once Flashes at the support if within warranty every 45 same time as the Sounder fault If not, replace alarm... -
Page 9: Alarm Test
ALARM TEST NOTE: The test button accurately tests the alarm’s smoke sensing circuit, there is The alarm must be properly attached to the no need to test your alarm with smoke. If base plate before it can be tested. your smoke alarm fails to give an audible test signal, please refer immediately to the a) Press the test button in the centre and trouble shooting guide at the end of this... - Page 10 NOTE: If the level of smoke reaching the to flash more rapidly than normal, alarm is very high, the alarm silence will be approximately once every 10 seconds. overridden and the alarm will continue to sound. 1. Briefly press and release the pause button, the alarm sound will shortly stop.
-
Page 11: Sleep Easy
SLEEP EASY™ vacuum cleaner fitted with the soft brush attachment. Low battery warnings often start at night or when it maybe inconvenient to replace your alarm. You can silence the audible chirp for a period of 8 hours by pressing the test button. Your smoke alarm will still detect smoke during this time of low battery warning silence. -
Page 12: Troubleshooting
Undue force may result in damage to the smoke alarm or the base plate, or be removed from its both For more information, contact your installer, or the FireAngel Technical base plate Support Team between 9am - 5pm Monday – Friday... - Page 13 Solution • Check the location of your smoke alarm (see "Application" and "Positioning") Your FireAngel • Check that your smoke alarm is definitely the source of the beeping; ensure smoke alarm the noise isn’t coming from another alarm (smoke/carbon monoxide/gas/...
-
Page 14: Disposal
Please recycle where facilities exist. Check severe weather etc.). It does not apply to retail stores, with your local authority, retailer or contact service centres or any distributors or agents. FireAngel Safety Technology Limited will not recognise any our technical support team for recycling/ changes to this warranty by third parties.
Need help?
Do you have a question about the Thermoptek ST-632 and is the answer not in the manual?
Questions and answers