Interlinking Your Wst-630 Smoke Alarms - FireAngel WST-630 User Manual

a guide when marking the position of the
drill holes With an appropriately sized
drill, drill the holes and insert the plastic
fixing anchors supplied (if required).
Base plate tabs
2. Install Base Plate
Fit the base plate to the ceiling or wall using
the screws provided
3. Fit Your Smoke Alarm
To fit to the base plate included in this pack,
position the alarm on the base plate then
twist it clockwise until the alarm is locked in
position Make sure the alarm is twisted on
6
fully
The power pack will now activate The red
LED on the front of the alarm should flash
approximately once every 45 seconds to show
that it is active
WARNING: Removing the smoke alarm from its
base plate will de-activate the unit and prevent
it from detecting smoke
4. Test Your Smoke Alarm
After fitting the alarm to the base plate, wait
for 5 seconds for the alarm to settle then test
the alarm, see 'Alarm Test'
INTERLINKING YOUR
WST-630 SMOKE ALARMS
This smoke alarm contains an inbuilt RF
module, and enables
interlink two or more smoke alarms and
create a network Therefore WST-630 alarms
need to be "learned in" or interlinked in
order to communicate with each other If
one alarm activates, all other interlinked smoke
alarms will also sound Note that WST-630s can
only be interlinked with other WST-630s and
you to wirelessly