Table of Contents
Advertisement
b
Installing Ground Clips (2/2)
b. Wrap three layers of waterproof tape.
Assemble a connector connected to the ground bar.
a. Insert the ground copper wires
into the OT terminal.
c. Install a heat shrink tubing onto
the joint between the OT terminal
and ground cable.
Connect the ground cable to the ground point.
Washer
Nut
•After connect the ground cable to the ground point, apply anti-rust lubricant to the ground point.
•The U-shaped clip used for grounding is the same as the fixture U-shaped clip.
c. Wrap three layers of PVC tape.
b. Use pliers to compress the copper wires tightly.
d. Heat around the heat shrink tubing so that it wraps the
OT terminal and ground cable tightly.
OT terminal
U-shaped clip
Ground point
46
d. Use the outdoor bundling strap to
bind the PVC tape tight at both ends.
Ground bar
Advertisement
Table of Contents
