Sealey VS301 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
Refer to instruction Wear eye
protection
manual
WARNING! Wear approved eye protection. Wear appropriate Personal Protective Equipment. A full range of Personal Protective Equipment is

available from your Sealey dealer.
WARNING! Ensure that Health & Safety, Local Authority Regulations and general workshop practice Regulations are adhered to when using tools.

 DO NOT use tools if damaged.
 Maintain tools to ensure that they are in an adequate condition for safe use and optimum performance.
 Ensure that a vehicle that has been raised by a jack is adequately supported. Use axle stands.
 DO NOT attempt to start or move a vehicle whilst in gear and with timing devices fitted.
 Wear suitable clothing to avoid snagging. DO NOT wear jewellery. Tie back long hair.
Account for all tools, parts and components being used. DO NOT leave these in or near the engine. Return tools to suitable storage after use.

 When not in use, store in a safe, dry childproof place.
 Keep children and unauthorised persons away from the work area.
s IMPORTANT! These instructions are provided as a guide only. Always refer to the vehicle manufacturer's service instructions
or a proprietary manual to establish the correct procedure and data.
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations. The Operator / user must

apply caution and common sense (good practical sense).
2. INTRODUCTION
Comprehensive and time saving kit of spark plug thread repair tools especially suitable for the repair of deep seated plug configurations. Kit of
tools incorporates taper and plug taps together with intergrated ream. Stepped tap ensures correct alignment of seat cleaner in existing spark
plug hole. Extension tools allow easy access to the bottom of the plug recess. Includes set of plug inserts.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . VS301.V2
Plug tap: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . M14x1.25
Step tap: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . M14x1.25; M16x1.25
Insert lengths: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9mm and 15mm
Replacement inserts; . . . . . . . . . . . . . VS301.9 (10pcs), VS301.15 (10pcs)
4. CONTENTS
Item
1
2 Step Tap (M14x1.25; M16x1.25)
3
4
© Jack Sealey Limited
INSTRUCTIONS FOR:
SPARK PLUG THREAD REPAIR KIT
MODEL No:
Description
Plug Tap (M14x1.25)
Wrench
T-bar
Original Language Version
VS301.V2
Part No: Item Description
VS301.05 5 Insert Drive
VS301.06 6 Seat Cleaner
VS301.03 7 Inserts 9mm/15mm
VS301.01 8 Allen Key (2.5mm)
Part No:
VS301.02
VS301.04
VS301.9/VS301.15
VS301.V2 Issue No: 1- 23/01/15