Sealey VS7020.V3 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
Refer to Wear eye
instruction protection
manual
WARNING! Ensure all Health and Safety, local authority, and general workshop practice regulations are strictly adhered to when using

tools.
DO NOT use tools if damaged or worn.

Maintain the tools in good and clean condition for best and safest performance.

Ensure all threads are clean and well lubricated.

Ensure vehicle is adequately supported with axle stands, ramps, etc. as appropriate.

Wear suitable clothing to avoid snagging. DO NOT wear jewellery. Tie back long hair.

Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.

Account for all tools and parts being used and DO NOT leave them in or on the vehicle.

IMPORTANT: Always refer to the vehicle manufacturer's service instructions, or proprietary manual, to establish the correct procedure and
data for the specific vehicle you are working on. These instructions for use are provided as a guide only.
2. INTRODUCTION
Comprehensive kit of tools for the fast and effective removal and Installation of wheel bearings on front-wheel drive vehicles. Reduces chances of
damage to hub and bearing. Heavy-duty steel drifts with phosphate coating to prevent corrosion. Heavyweight drive screw for use with impact tools.
Also suitable for removing and installing large industrial bearings. Supplied in carry-case.
3. SPECIFICATIONS
Model No:
Drift Sizes Ø:
End Cap Ø:
Sleeve Ø External:
Hub screw length:
Hub screw drive:
4. CONTENTS
© Jack Sealey Limited
INSTRUCTIONS FOR:
WHEEL BEARING
REMOVAL / INSTALLATION KIT
MODEL No:
VS7020.V3
55, 60, 64, 67, 73, 75, 78, 82, 84, 88mm
50mm
76, 86, 92, 101mm
210mm
32, 38mm
VS7020.V3
Original Language Version
VS7020.V3 Issue: 2(I) - 16/12/15