Sealey VS821 Instructions

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLease read tHese instructions carefuLLy. note tHe safe oPerationaL reQuireMents, WarninGs & cautions. use tHe
Product correctLy and WitH care for tHe PurPose for WHicH it is intended. faiLure to do so May cause daMaGe and/or
PersonaL inJury and WiLL inVaLidate tHe Warranty. KeeP tHese instructions safe for future use.
1. safety
WarninG! Familiarise yourself with the application and limitations, as well as any potential hazards, of this product. Ensure that Health

and Safety, local authority and general workshop practice regulations are adhered to when using.
 do not use pressure reservoir, or its ancilliaries if damaged.
 do not use the pressure reservoir to perform a task for which it is not designed.
 do not allow untrained persons to use the pressure vessel.
 do not use when tired or under the influence of drugs, alcohol or intoxicating medication.
 Use approved parts and approved spare parts only.
 Maintain in a good and clean condition for the best and safest performance.
 Ensure that the ignition key of the vehicle being worked on is removed, to prevent inadvertent engine cranking.
 If the vehicle to be worked on is raised, ensure that it is adequately supported with axle stands or ramps and wheel chocks.
 Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.
 Wear suitable clothing to avoid snagging. do not wear jewellery and tie back long hair.
 Keep children and unauthorised persons away from the work area.
 Keep work area clean and tidy and free from unrelated materials.
 Ensure the work area has adequate lighting.
Brake fluid Precautions
 Always read and comply with the warnings on the brake fluid container.
 Wear eye protection and keep skin contact to a minimum. If brake fluid enters eyes rinse with plenty of water and seek medical
advice. If swallowed seek medical advice immediately.
WARNING! Brake fluid is flammable - keep away from sources of ignition, including hot surfaces e.g. exhaust manifold.

WARNING! Brake fluid will damage paintwork. Any spillage should be flushed with water immediately.

Always read and comply with the warnings on the brake fluid container.

WARNING! DO NOT pollute the environment by allowing uncontrolled discharge of fluids. Dispose of waste liquids in accordance with

local authority regulations.
 After use, clean equipment and store in a cool, dry, childproof area.
2. introduction
Professional one man brake and clutch bleeder that uses air from the vehicle tyre. Reservoir holds 1.5ltr of hydraulic fluid - flush the entire
system with one fill without the risk of running the reservoir dry. Maximum pressure of 30psi makes the unit suitable with ABS systems.
Features a fluid shut off valve to prevent accidental spillage and pressure release valve. Fitted with Ø42mm cap with 90° angled connector
which is suitable for most European models. For other applications order optional Brake Reservoir Cap 42mm Straight Connector -
Model No. VS820SA (see fig.6) or Universal Adaptor - VS820UA (see fig.5).
© Jack Sealey Limited 2013
INSTRUCTIONS FOR:
PneuMatic BraKe & cLutcH BLeeder
Vs821
MODEL No:
fig.1
Original Language Version
fig.2
VS821 Issue: 1 - 13/03/14