Table of Contents
Advertisement
Connecting the Optional Wireless Receiving Amplifi er
1
Connect the front, center and Subwoofer speakers to the main unit,
referring to pages 12~14.
2
With the main unit turned off, insert the TX card into the TX Card
Connection(WIRELESS) on the back of the main unit.
•
Hold the TX card so that the slanted side faces downward and insert the
card into the port.
•
The TX card enables communication between the main unit and
the wireless receiver.
3
Connect the left and right rear speakers to the wireless receiving
module.
4
Plug the power cord of the wireless receiving module in the wall
outlet and switch the power switch <ON>.
16
TX card
Slanted side faces down
•
Do not insert a card other than the TX card dedicated for the product.
The product might be damaged or the card may not be removed easily.
•
Do not insert the TX card upside down or in the reverse direction.
•
Insert the TX card when the main unit is turned off.Inserting the card
when it is turned on may cause a problem.
•
If the TX Card is inserted, sound is not output from the Rear Speaker
connectors on the main unit.
(Con't)
Resetting the Wireless Receiving Module
Reset the system if a communication failure occurs, or if the Link indicator (blue LED) on the wireless receiver does not
light up and the <REAR CHECK> message blinks on the main unit's display.
Reset the system while the main unit and the wireless receiver module (SWA-3000) are in Power Standby mode.
•
When the wireless receiving module setting is complete, no audio signal is output from the Rear Speaker Output
Connector on the back of the main unit.
•
The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and
moisture.
•
For optimal listening performance, make sure that the area around the wireless receiver module location is clear
of any obstructions.
•
Sound will be heard from the wireless rear speakers in DVD 5.1-CH or Dolby Pro Logic II mode only.
•
In 2-CH mode, no sound will be heard from the wireless rear speakers.
•
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too
close to the main unit, some sound interruption may be heard due to interference.
•
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device
that uses the same frequency (2.4GHz) near the system, some sound interruption may be heard due to
interference.
•
The transmission distance of radio wave is about 10m, but may vary depending on your operating environment.
If a steel-concrete wall or metallic wall is between the main unit and the wireless receiver module, the system
may not operate at all, because the radio wave cannot penetrate metal.
1
With the main unit turned off, press and hold the remote
control's REMAIN button for 5 seconds.
The STANDBY LED on the front panel of the wireless
receivermodule blinks.
2
With the wireless receiver module turned on, use a ball point
pen or a pair of toothpick to press the RESET button on the
back of the unit.
The STANDBY LED on the front panel of the wireless receiver
module blinks 2 Times.
3
Turn on the main unit.
The LINK LED of the wireless receiver module is lit and the
Reset is completed.
If Power Standby mode continues, repeat Steps 1 to 3 above.
GB
17
Hide quick links:
Advertisement
Table of Contents
