Panasonic EP-MA03 Operating Instructions Manual page 10

2. Moving the unit and setting it up.
• Since the unit is very heavy (approximately 63 k
• Put the unit down slowly and carefully watch your step.
Lifting the unit to install and setup the unit
•
hold it correctly.
Place the controller and the
power cord on the seat.
Hold the plastic part.
Install the unit with the backrest away
from the wall.
Make sure the backrest does not touch the wall.
More than 10
(When the backrest is fully upright)
(When the backrest is fully reclined)
EN10
g), be careful to avoid back injuries. (The unit must be carried by two persons.)
Placement area
(place a mat, etc.)
Do not hold here.
Doing so may result
in damage or injury.
stiff plastic part inside.
cm
At least 3 cm
Assembly
Install the elbow component into the body.
Insert the elbow component into 3 points of the body.
1
Then press it downward.
2
Internal side of
elbow component.
Do not pinch the finger.
※
Fix with screws
(One screw on front and rear separately)
Insert the clamp screw into the screw hole. After aligning
1
with the screw hole on the body, press it downward.
Secure the clamp screw on the edge of Allen Key and
2
then fasten the screw.
①
Screw Hole
Fasten this side first.
※
Screw Fastening Method
Allen Key
• Horizontally align with the hollow
• If inserting the screw into the screw
Screw Hole
Insertion Section
①
Screw Hole
②
Allen Key
②
②
②
and then lock tight.
hole improperly, then it may damage
the screw when fastening the screw
with Allen Key.