Technical Data; Technical Data Of The G115D Converter With Simogear Geared Motor; General Technical Data - Siemens SINAMICS G115D Operating Instructions Manual

Technical data

10.1 Technical data of the G115D converter with SIMOGEAR geared
motor
For more information on the technical data of the geared motors, refer to the following
chapter:
10.1.1

General technical data

Electrical data
Property
Line voltage
Line supply configurations
Line frequency
Output frequency
Converter efficiency
Power factor λ
cos φ
Line impedance
Inrush current
Overvoltage category
Maximum short-circuit current (SCCR
or Icc)
Minimum short-circuit current
Earth fault current
Electromechanical (EM) brake
For IT system, only permissible when the functional grounding in the converter has been removed.
1)
SINAMICS G115D distributed drive
Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002
Additional information on the SIMOGEAR geared motor (Page 385)
Explanation
• For systems according to IEC:
– 3 AC 380 V (-10 %) ... 480 V (+10 %)
• For systems according to UL:
– 3 AC 380Y/220 V ... 480Y/277 V
The actual permissible line voltage depends upon the installation altitude.
TN, TT, IT
1)
Not for corner-grounded network.
Permissible line supplies (Page 48)
50 Hz/60 Hz (±10%)
0 Hz ... 550 Hz in U/f
0 Hz ... 240 Hz in SLVC (default)
96% ... 98%
0.73 ... 0.90
0.98 ... 0.99
Uk<4% (RSC>25)
Less than 2 × rated input current.
The converter can withstand 100000 power cycles with an interval of 120 s.
III, according to IEC 61800-5-1
When using fuses: 65 kA rms
You can find the data for further overcurrent protection devices on the Internet:
Branch protection and short-circuit strength according to UL and IEC
(https://support.industry.siemens.com/cs/ww/en/ps/27867)
5 kA rms
The converter can be operated with a type B 300 mA RCD.
• 180 V DC
Rated current: 0.8 A
–
– Disconnection on the DC side permits "fast" braking
10
359