Panasonic SF2B Series Instruction Manual page 21

3. Mount the brackets so that the protrusion of the A part and the B part are overlapped.
B part to be attached to the top or bottom side of this device differs depending on the direc-
tion of mounting described as the following chart.
When mounting at the right
side of the front surface
Protrusion of
the B part
Front side of the main body
4. Mount the mounting bracket on to the mounting surface with two hexagon-socket head bolts
[M5 (purchase separately)] temporarily.
5. Adjust the height of the emitter and the receiver to level with the elongate holes and then
tighten the hexagon-socket head bolts.
<For rear mounting>
Hexagon-socket
head bolt [M5 (Pur-
chase separately)]
Note: For the models that the intermediate supporting bracket (MS-SF2B-2) is enclosed with, be sure to use the
intermediate supporting bracket (MS-SF2B-2). For details, refer to <When the intermediate mounting
bracket (MS-SF2B-2) (accessory) is used>.
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
Ramco Innovations | www.ramcoi.com | 800-328-6236 | nsales@ramcoi.com
Hexagon-socket head bolt
[M3 (length 5mm)]
B part
Protrusion of
the A part
Hexagon-socket
head bolt [M5 (Pur-
chase separately)]
When mounting at the left
side of the front surface
Protrusion of Protrusion of
the B part the A part
Front side of the main body
<For side mounting>
Hexagon-socket head bolt
[M3 (length 5mm)]
B part
Hexagon-socket
head bolt [M5 (Pur-
chase separately)]
21