Device Placement - Panasonic SF2B Series Instruction Manual

2-3-4 Device Placement

This is the configuration when two or more sets of emitter and receiver facing each other are placed
without series or parallel connection between them. It is used for the case that there is a problem in
wiring or for system evaluation in case of addition of equipment. Perform an operation test by refer-
ring to "2-6-2 Operation Test."
● Refer to the examples of device placement given below and understand them
thoroughly before installing the devices. Improper sensor placement could
cause device malfunction, which can result in death or serious injury.
● If this device is used in multiple sets, arrange them to avoid mutual interference.
If mutual interference occurs, it can result in death or serious injury.
<Example of device placement>
1) Install emitter and the receiver back to back
Receiver Emitter
3) Arrange the emitter and the receiver horizontally on
opposite sides.
Emitter
Receiver
<Reference>
The above figures are just examples of device placement. If there are any questions or problems, please
contact our office.
Position the emitter and receiver so that their cables are aligned. Failure to do so
will cause the system to malfunction.
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
Ramco Innovations | www.ramcoi.com | 800-328-6236 | nsales@ramcoi.com
Emitter Receiver
Receiver
Emitter
Cabel
2) Arrange the emitter and the receiver vertically on opposite
sides.
Emitter
Receiver
4) Install a barrier
Receiver Emitter
Barrier
Cabel
Cabel
Receiver
Emitter
Receiver Emitter
Cabel
19