Mitsubishi Electric 700 Series Installation Manualline page 15

Control circuit specifications
3.3 Control circuit specifications
(1) Standard control circuit terminal model
Control circuit terminal layout
Terminal screw size
M3: (Terminal A, B, C)
M2: (Other than the above)
Wiring method
1) Strip off the sheath of the wire of the control circuit to wire.
Strip off the sheath about the size below. If the length of the sheath peeled is too long, a short circuit may occur among
neighboring wires. If the length is too short, wires might come off.
Wire the stripped wire after twisting it to prevent it from becoming loose. In addition, do not solder it. Use a blade terminal
as necessary.
Terminal A, B, C
Other than the above
Blade terminals available on the market: (as of Oct. 2008)
Phoenix Contact Co.,Ltd.
Terminal Screw Size
M3 (terminal A, B, C)
M2 (other than the above)
NICHIFU Co.,Ltd.
Terminal Screw Size
M3 (terminal A, B, C)
M2 (other than the above)
2) Loosen the terminal screw and insert the cable into the terminal.
3) Tighten the screw to the specified torque.
Undertightening can cause cable disconnection or malfunction. Overtightening can cause a short circuit or malfunction
due to damage to the screw or unit.
Tightening torque: 0.5N·m to 0.6N·m (terminal A, B, C)
0.22N·m to 0.25N·m (other than the above)
* Screwdriver: Small flathead screwdriver (Tip thickness: 0.4mm/tip width: 2.5mm)
12
Wire stripping length
L
L(mm(inches))
6 (0.24)
5 (0.2)
2
Wire Size (mm )
With Insulation Sleeve
0.3, 0.5
0.75 AI 0,75-6GY
0.3, 0.5
Blade Terminal Product
2
Wire Size (mm )
0.3 to 0.75
10 2 5 4 RUN FU SE
RL
AM
A B C
Blade Terminal Model
Without Insulation Sleeve
AI 0,5-6WH
AI 0,5-6WH
Insulation Product Number
Number
BT 0.75-7
RM RH MRS RES SD PC STF STR
Blade Terminal
Crimping Tool
A 0,5-6
A 0,75-6
CRIMPFOX ZA3
A 0,5-6
Blade Terminal
Crimping Tool
VC 0.75
SD SD
NH 67