Appendix B - Tracking - microHAM CW KEYER Manual

NOTE: Tracking is experimental code for linking the transceiver frequency to a tracking receiver
begun in Router 7.5.0 . Bidirectional frequency tracking is not supported.
Radio: Specifies SDR receiver model. Current choices are Perseus and TS-2000 Compatible.
Port: Specifies COM port used to communicate with the SDR. Must be COM 10 for Perseus. The
port must be defined as a "virtual serial port for router interface".
Source QRG: Specifies the frequency for the SDR to track. Where two sources are shown (e.g.,
VFO A, VFO B) the first source will be sent to the SDR in Receive and the second source in
Transmit.
Offset: Frequency offset between the transceiver frequency and the frequency sent to the SDR.
This is useful when the transceiver is used as an IF with a transverter. Default is 0Hz,
resolution is 1Hz.
Track modes: Send mode as well as frequency to the SDR software.
The bottom two-thirds of the window is a serial communication monitor which displays the data sent
to the SDR for diagnostic purposes.
microHAM © 2016 All rights reserved
APPENDIX B – Tracking
The log is a circular buffer; the size is set in Router | General.
28