External Keyboard - microHAM CW KEYER Manual

CW Keyer allows transmitting CW from a PS2 keyboard attached to the Remote jack. A numeric PS/2
keypad may also be used to record and play back CW messages (memory keyer).
NOTE: The keyboard or keypad must be PS/2. A USB device and PS/2 adapter. will not work properly.
CW Keyer allows keyboard transmission, saving messages to memory, playing stored messages, setting
speed, and tune mode. During record mode it is possible to record characters typed on the keyboard or
entered on the paddle.
Number Pad Key
NUM LOCK
NUM *
NUM 0
NUM 1 – NUM 9
NUM DEL
NUM /
CW Speed mode
NUM +
Serial Number mode
CW Speed mode
NUM -
Serial Number mode
CW Speed Mode
NUM ENTER
Serial Number mode
microHAM © 2016 All rights reserved

6 - EXTERNAL KEYBOARD

Standard Function
Key
Start/Stop recording of message -
(record mode is indicated by NUM LED, if present)
Tune (Cancel by NUM 0 or ESC)
Playback: Stop transmitting (clear message/buffer)
ESC
Recording: abort recording without saving the message
Playback: Play message
F1 – F9
Recording: Select message slot to record
Loop last message – default is one second. Following NUM
DEL with a number on the numeric pad will set the delay
Switch between Speed mode and Serial Number mode
ALT Hold to set serial number
PG UP Increase CW speed (step defined by configuration)
UP Decrement number by one
PG DN Decrease CW speed (step defined by configuration)
DN Decrement number by one
HOME Reset Speed to Pot
Transmit number with optional report and increase number
ENTER
by one (format defined by configuration)
F10 Toggle PTT
| Transmit Gap (½ dit space)
Transmit a space.
Space character is pushed into the type ahead buffer and
transmitted in sequence
0-9, A-Z Transmit the character. If "type ahead" is selected, the
!"$&='(),-./:; character is pushed into the type ahead buffer and
? transmitted in sequence
23
If "type ahead" is selected, the