Connecting +24 V Dc External Power Supply - ABB ACS800 Series Hardware Manual

166

Connecting +24 V DC external power supply

1. Break off the tab covering the +24 V DC power input connector with pliers.
2. Lift the connector upwards.
3. Disconnect the wires from the connector (keep the connector for later use).
4. Isolate the ends of the wires individually with insulating tape.
5. Cover the isolated ends of the wires with insulating tape.
6. Push the wires inside the skeleton.
7. Connect the wires of the +24 V DC external power supply to the disconnected
connector:
if a two-way connector, + wire to terminal 1 and - wire to terminal 2
if a three-way connector, + wire to terminal 2 and - wire to terminal 3.
8. Plug the connector in.
X34
2
External +24 V DC power supply for the RMIO board via terminal X34
Frame sizes R2 to R4
1
Frame sizes R5 and R6
3
1
4
4