Removal And Replacement; Required Tools; Preparing For Removal; Removing Hägglunds Ca 10 - Ca - Bosch Rexroth Hägglunds CA Series Installation And Maintenance Manual

38/52

Removal and replacement

DANGER!
CAUTION!
NOTICE!
RE 15354-WA/04.2015, Installation and maintenance manual, Hägglunds CA 10 - CA 40, Bosch Rexroth Mellansel AB
11 Removal and replacement

11.1 Required tools

In addition to standard tools are also needed:
▶ Lifting tool/device
▶ Lifting eyes

11.2 Preparing for removal

1. Decommission the entire system as described in the instruction manual for the
machine or system.
• Relieve pressure in the hydraulic system according to the instructions of
the machine or system manufacturer.
• Make sure that the relevant system components are not under pressure or
voltage.
2. Protect the complete system against being energized.
3. Remove the hoses, cables and pipelines from the motor.
11.3 Removing Hägglunds CA 10 - CA 40
Proceed as follows to remove the motor:
Danger from suspended loads!
▶ See chapter 2.6: Product-specific safety instructions
Contact with hydraulic fluid!
▶ See chapter 2.6: Product-specific safety instructions
Escaping or spilling hydraulic fluid!
▶ See chapter 2.6: Product-specific safety instructions
Removing the motor, flange mounted
1. Secure the motor to a lifting device, see chapter 6.1: Product transport.
2. Place the oil barrel below the motor.
3. If the motor is flange mounted, unscrew the motor from the flange.
4. Pull the motor off the shaft.

11.4 Preparing the components for storage or further use

Proceed as described in chapter 6.2: Product storage.
▶ Wrench
▶ Oil barrel(wide opening)