Product-Specific Safety Instructions - Bosch Rexroth Hägglunds CA Series Installation And Maintenance Manual

10/52 Safety instructions
RE 15354-WA/04.2015, Installation and maintenance manual, Hägglunds CA 10 - CA 40, Bosch Rexroth Mellansel AB
specifically stated and allowed in the product documentation, e.g. in explosion risk
areas or in safety-critical controls (operating safety).
• You may only commission the product if it has been determined that the end
product (e.g. machinery or a system) into which the Bosch Rexroth products are
installed complies with the country-specific provisions, safety regulations and
standards of the application.

2.6 Product-specific safety instructions

The safety instructions below apply to chapters 6: Transport and storage to 15:
Technical data.
Danger from excessively high pressure!
Danger to life or risk of injury, damage to equipment!
Operating the motor above the permissible maximum pressure can cause
components to burst and hydraulic fluid to escape under high pressure.
▶ Operate the motor only within permissible maximum pressure.
Danger from suspended loads!
Danger to life or risk of injury, damage to equipment!
Improper transportation may cause the Hägglunds motors to fall down lead to
injuries e.g. crushing or broken bones or damage to the product.
▶ Make certain that the forklift truck or lifting device has adequate lifting capacity.
▶ Never stand under or put you hands under suspended loads.
▶ Ensure your position is stable during transportation.
▶ Use your personal protective equipment (e.g. safety glasses, safety gloves,
suitable working clothes, safety shoes).
▶ Use suitable lifting device for transport and storage, installation and for removal
and repair. Make sure the motor is well mounted or anchored when the lifting
device is disconnected.
▶ Observe the prescribed position of the lifting strap.
▶ Observe the national laws and regulations on work and health protection and
transportation.
Pressurized machine/system!
Danger to life or risk of injury, serious injuries when working on machines/systems
not shutdown! Damage to equipment!
▶ Protect the complete system against being energized.
▶ Make sure that the machine/system is depressurized. Please follow the machine/
system manufacturer's instructions.
▶ Do not disconnect any line connections, ports and components when the
machine/system is pressurized.
▶ Switch off all power-transmitting components and connections
(electric, pneumatic, hydraulic, mechanical) in accordance with the
manufacturer'sinstruction and secure them against being switched back on.
DANGER