Product Storage; Standing The Motor On A Flat Surface - Bosch Rexroth Hägglunds CA Series Installation And Maintenance Manual

18/52 Transport and storage
Fig. 7: Hägglunds CA 10 - CA 40 standing on a flat surface
RE 15354-WA/04.2015, Installation and maintenance manual, Hägglunds CA 10 - CA 40, Bosch Rexroth Mellansel AB

6.2 Product storage

The motor is delivered with internal protection in the form of an oil film with vapor
state corrosion inhibitors (Shell VSI 8235), and external protection in the form of
an anti-rust film. This provides sufficient protection for indoor storage in normal
temperatures for about 12 months.

6.2.1 Standing the motor on a flat surface

Unsecured motor can fall!
Danger to life or risk of injury, damage to equipment!
▶ When in storage or during oil filling, the motor must always be secured from
falling.
Incorrect placement of the motor!
Risk of damage to equipment.
▶ When in storage with shaft vertical, the motor must always be placed with the
hollow shaft facing down.
▶ It is also advisable to provide supports att the mounting surface of the motor,
see Fig. 7: Hägglunds CA 10 - CA 40 standing on a flat surface alt.B) Standing
with shaft vertical .
When the motor is placed on a flat surface such as a floor, it must stand either on
its outer diameter or on the suitably protected end face of the hollow shaft. It is also
advisable to provide supports shown in Fig. 7: Hägglunds CA 10 - CA 40 standing on a
flat surface.
A) Standing with
shaft horizontal
DANGER
NOTice
B) Standing with
shaft vertical
Support
DD00070624