Siemens SIMOTION ADI4 Manual page 4

Preface
Standards and approvals
Our products meet the requirements of EU directive 89/336/EEC "Electromagnetic
Compatibility" and the harmonized European Standards listed therein.
The EC declaration of conformity is available on the Internet at
http://support.automation.siemens.com/WW/view/eng/15257461.
You will find detailed information about approvals and standards in the "Supplemental
SINAMICS System Components for SIMOTION" manual.
Safety information
The following notices are intended to ensure both your personal safety and to prevent
damage occurring to the products described or any connected devices and machines.
Hazardous voltages are present in this electrical equipment during operation.
Actions by an unqualified device operator or failure to observe the warning notices may
result in serious physical injury or material damage. Only suitably qualified personnel who
are trained in assembling, installing, commissioning or operating the product should work
on this device.
Should it be necessary to test or take measurements on live equipment, then the
specifications and procedures defined in Accident Prevention Regulation VBG 4.0 must be
adhered to, in particular §8 "Permissible deviations when working on live components". A
suitable electric tool must be used.
Repairs to devices that have been supplied by Siemens must only be carried out by
Siemens Customer Service or by repair centers authorized by Siemens. When replacing
parts or components, only use those parts or components that are included in the spare
parts list.
Before opening the device, always disconnect the power supply.
EMERGENCY STOP devices complying with EN 60204 IEC 204 (VDE 0113) must remain
effective in all automation equipment modes. Resetting the EMERGENCY STOP device
must not cause an uncontrolled or undefined restart.
Additional external measures must be taken, or devices must be created that ensure or
force a safe operational state even when there is a fault (e.g. using independent limit value
switches, mechanical locks, etc.) at any location in the automation equipment where faults
might cause major material damage or even physical injury, in other words, where faults
could be dangerous.
4
WARNING
WARNING
SIMOTION ADI4 - Analog Drive Interface for 4 Axes
Manual, 05/2009, 6FC5 297-0BA01-0BP6