Maintenance; Replacing A Bulb - Toro T4240 Installation Instructions Manual

If the lights operate incorrectly, check the wiring connections
against the diagram, reconnect the wires as necessary, and
check the operation of the lights again.
1. In order to comply with the road vehicle lighting
regulations adjust the front dipped beam headlights so
that the horizontal part of the cutoff of the beam is
inclined downward.
2. To set the front dipped-beam headlights, slacken the
nut located under the headlight, adjust as required, and
tighten the nut.

Maintenance

Replacing a Bulb

Replace all worn or damaged parts with genuine Toro parts.
Ensure that all lights are working on a regular basis.
1. Remove the lens cover; refer to
2. Replace the bulb.
3. Install the lens cover.
4. Adjust the lights to ensure that they comply with local
road legislation.
1. Headlight
2. Rubber bushing
3. Headlight bulb
7
Figure 8.
Figure 8
4. Front indicator light
5. Front indicator bulb
6. Side indicator bulb
g206685