Toro T4240 Installation Instructions Manual page 5

Fuse Box (front view)
1. 10 A
Installing the Front Lights
Kit 02845 is required for the T4240 so that the front lights
can be clearly seen with the cutting units raised.
To install the fitting kit 02845 with the lighting kit 02844 to a
T4240 traction unit, follow these instructions.
1. Assemble the front light arm assemblies as shown in
Figure 7.
2. Fit the front light arm assemblies to the machine and
check that they spring forward freely when pushed
back and released.
3. Use the cable ties to secure the sidelight cables to the
brace and the front arm. Take care to ensure that
the wire is not strained when the front light arm is
articulated through its full range of travel.
4. Connect the positive (+) battery lead first and then
connect the negative (-) battery lead.
5. Close the operator platform and secure in place with
the platform latching mechanism. Refer to the traction
unit Operator's Manual.
Figure 6
2. 15 A
g206692
5