Table of Contents
Advertisement
CAUTION
The spring is under tension when
installed and can cause personal injury.
Wear safety glasses and be careful when
removing the spring.
7.
Remove the deck belt from the clutch and clutch
stop
(Figure
57).
8.
Install the new belt.
9.
Install the tension spring and lower hydraulic
hose.
10.
Install the drain plugs and torque to 22 to 27
N∙m (16 to 20 ft-lb).
11.
Add hydraulic fluid to the fill level.
12.
Install the hydraulic-reservoir cap.
13.
Run the machine for 10 minutes and verify that
the hydraulic fluid is at the correct level.
Controls System
Maintenance
Adjusting the
Motion-Control Levers
If the motion-control levers do not align horizontally,
adjust the right side motion-control lever.
1.
Disengage the PTO, move the motion-control
levers to the N
engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Push the motion-control levers down out of the
N
-
EUTRAL
LOCK
4.
Check if the right motion-control lever aligns
horizontally with the left motion-control lever
(Figure
58).
1. Left motion-control lever
2. Right motion-control lever
in the Neutral-lock position
5.
To adjust the motion-control levers horizontally,
you must adjust the cam.
6.
Release the cushion from the rear of the
machine.
7.
Loosen the nut holding the cam
43
-
position, and
EUTRAL
LOCK
position
(Figure
58).
Figure 58
3. Check the horizontal
alignment here
4. Right motion-control lever
(Figure
g009436
59).
Advertisement
Table of Contents
