Table of Contents
Advertisement
Throttle Control
The throttle controls the engine speed, and it has a
continuous-variable setting from the S
position
(Figure
5).
Power-Takeoff (PTO) switch
Use the power-takeoff (PTO) switch to start and stop
powered attachments
(Figure
Ignition Switch
Use this switch to start the engine. It has 3 positions:
S
, R
, and O
.
TART
UN
FF
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction.
Fuel-Shutoff Valve
Close the fuel-shutoff valve (located on the left side
of the fuel tank) when transporting or storing the
machine
(Figure
4).
Accessory Frame
Use the accessory frame to attach only Toro-approved
accessories to the machine
Operator's Manual for the accessory for installation
instructions.
Accessory-Frame Lock
The accessory-frame lock holds the frame in place on
the machine using the lock pin. Always lock the frame
unless a hydraulic kit is installed with an accessory
on the machine
(Figure
Electronic-Control Unit
Malfunction-Indicator Light
The electronic-control unit (ECU) continuously
monitors the operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction-indicator light (MIL) is illuminated
5).
The MIL is the red light located in the console panel.
When the MIL illuminates, make initial troubleshooting
checks.
If these checks do not correct the problem, further
diagnosis and servicing by an Authorized Service
Dealer is necessary.
to F
LOW
5).
(Figure
4). Refer to the
4).
(Figure
Adjustable Casters
When using the machine with an attachment, refer
to the Operator's Manual for that attachment for the
AST
correct caster position
machine without an attachment installed on the front
of the machine.
1. Caster bolt and nut in front
caster hole
Specifications
Note:
Specifications and design are subject to
change without notice.
Width
Length with platform down
Length with platform up
Height
Weight
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
To best protect your investment and maintain optimal
performance of your Toro equipment, count on Toro
genuine parts. When it comes to reliability, Toro
delivers replacement parts designed to the exact
engineering specification of our equipment. For peace
of mind, insist on Toro genuine parts.
10
(Figure
6). Do not operate the
Figure 6
Right Caster Shown
2. Caster holes
122 cm (48 inches)
191 cm (75 inches)
155 cm (61 inches)
122 cm (48 inches)
308 kg (680 lb)
g033081
Advertisement
Table of Contents
