Table of Contents
Advertisement
Stopping the Machine
To stop the machine, move the motion-control levers
to neutral, and then move them to the N
position, disengage the power takeoff (PTO), and turn
the ignition key to the O
Engage the parking brake when you leave the
machine; refer to
Operating the Parking Brake (page
15).
Note:
Remember to remove the key from the ignition
switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and engage
the parking brake when leaving the machine
unattended, even if just for a few minutes.
Using Weights
•
Install weights to improve balance. You can add or
remove weights to create optimized performance
under different operating conditions and for your
preference.
•
Add or remove weights 1 at a time until you
achieve the desired handling and balance.
•
Refer to the Operator's Manual of attachments for
recommended weights.
Note:
Contact an Authorized Service Dealer to order
a weight kit.
WARNING
Excessive weight changes can affect the
handling and operation of the machine.
This could cause serious injury to you or
bystanders.
• Make weight changes in small increments
only.
• Evaluate the machine after each weight
change to ensure that you can operate the
machine safely.
EUTRAL
position.
FF
After Operation
-
After Operation Safety
LOCK
General Safety
•
Clean snow and debris from the drives, mufflers,
and engine compartment to help prevent fires.
Clean up oil or fuel spills.
•
Shut off the fuel before storing or transporting the
machine.
•
Disengage the drive to the attachment whenever
you are transporting or not using the machine.
•
Use full-width ramps for loading the machine into
a trailer or truck.
•
Tie the machine down securely using straps,
chains, cable, or ropes. Both front and rear straps
should be directed down and outward from the
machine.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Shut off the fuel before storing or transporting the
machine.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Preventing Freeze-up after
Use
•
In snowy and cold conditions, some controls and
moving parts may freeze. Do not use excessive
force when trying to operate frozen controls.
If you have difficulty operating any control or part,
start the engine and let it run for a few minutes.
Thaw frozen parts before operating the machine.
•
After using the machine, let the engine run for a
few minutes to prevent moving parts from freezing.
Shut off the engine, wait for all moving parts
to stop, and remove all ice and snow from the
machine.
20
Advertisement
Table of Contents
