Table of Contents
Advertisement
Brake Maintenance
Servicing the Brake
Before each use, check the brakes on a level surface
and slope.
Always engage the parking brake when you shut off
the machine or leave it unattended.
Important:
If the parking brake does not hold
securely, adjust it.
Checking the Parking Brake
Service Interval: Before each use or daily
1.
Park the machine on a level surface and
disengage the PTO.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Disengage the parking brake.
4.
Engage the parking brake and ensure that the
machine does not move.
5.
Adjust the brake if needed; refer to
Brakes (page
42).
Adjusting the Brakes
1.
Remove the fuel tank; refer to
Fuel Tank (page
2.
Loosen the bolt on the cable clamp on the left
side of the machine.
Figure 55
1. Cable
2. Cable clamp
3.
Pull down on the cables until they are taut.
4.
Tighten the nut.
5.
Install the fuel tank, cross bracket, and cushion.
Adjusting the
Removing the
35).
3. Bolt and nut
Belt Maintenance
Replacing the Transmission
Belt
Service Interval: Every 1,000 hours—Replace the
1.
Remove the fuel tank; refer to
Fuel Tank (page
2.
Remove the hydraulic-reservoir cap.
3.
Locate the drain plugs in the bottom of the
transmission and place a drain pan under the
plug
(Figure
1. Drain plug
4.
Allow the hydraulic fluid to drain from the
machine.
5.
Remove the lower hydraulic hose
g031396
1. Lower hydraulic hose
2. Transmission belt
6.
Remove the tension spring
42
transmission belt.
Removing the
35).
56).
Figure 56
(Figure
Figure 57
3. Tension spring
(Figure
g193360
57).
g031345
57).
Advertisement
Table of Contents
