Table of Contents
Advertisement
Installing Boards and Daughter Cards
Warning
Before installing boards and daughter cards, ensure that the device and cabinet are adequately grounded.
Before handling a board or daughter card, wear a grounded ESP strap to avoid electrostatic damage to components.
Slot Assignment
AUX
CONSOLE
4
MPU
ACT
LINK
RESET
ACT
ALM
RUN
OFL
CLK
TOD
MGMT-ETH
LPU/SPU
LPU/SPU
LPU/SPU
~100-120V;
~200-240V;
50/60Hz;16A
Install a board
1
Determine the slot for the board to be installed based on hardware planning and remove the filler panel from the slot.
2
Extend the ejector levels of the board, insert the board fully into slot, and rotate the ejector level to the front of the board so
that the board is fully inserted in the slot.
3
Use a Phillips screwdriver to tighten the captive screws to the board.
1
Install a daughter card
1
Remove the filler panel from the board.
2
Smoothly insert the daughter card into the board along the guide rail.
3
Use a Phillips screwdriver to tighten the captive screws to the board.
1
AUX
CONSOLE
4/5
MPU
5
ACT
LINK
RESET
ACT
ALM
RUN
OFL
CLK
TOD
MGMT-ETH
3
3
2
2
1
1
~100-120V;
~200-240V;
50/60Hz;16A
2
2
3
a
b
3
7
Advertisement
Table of Contents
