Table of Contents
Advertisement
Analog Audio Connection ([IN] and [OUT] Connectors)
Audio I/O Connection
Analog Audio Connection ([IN] and [OUT] Connectors) (DME24N only)
The DME24N includes [IN] and [OUT] connectors for 8 channels of analog audio input and output. Wire
the supplied Euroblock plugs as shown below. Head amplifier gain and phantom power settings can be
made via the Utility display HA page described on page 52 of this manual, or via the DME Designer
application.
Euroblock Connection
Please be sure to use the supplied Euroblock plugs. If you lose them, contact your nearest Yamaha dealer.
• To prepare the cable for attachment to a Euroblock connector, strip the wire as shown
in the illustration, and use stranded wire to make connections. With a Euroblock
connection, the stranded wire may be prone to breakage because of metal fatigue
due to the weight of the cable or due to vibration. When rack-mounting your
equipment, use a lacing bar when possible to bundle and fasten the cables.
• If cables will be frequently connected and disconnected, as in the case of a portable
installation, we recommend that you use ferrules with insulation sleeves. Use a
ferrule whose conductor portion has an external diameter of 1.6 mm or less, and a
length of approximately 7 mm (such as the AI0,5-6WH made by the Phoenix Contact
corporation).
CAUTION
1.
NOTE
A slotted screwdriver with a blade width of about 3 millimeters is
recommended.
2.
26
DME64N/DME24N Owner's Manual
If you use stranded wire, do not tin (plate with solder) the exposed end.
Loosen terminal screws.
Insert cables.
Cable preparation
Loosen.
Slotted Screwdriver
Terminal Screw
Euroblock Plug
approx.
7 mm
1.6 mm
approx.
or less
7 mm
3 mm
Advertisement
Table of Contents
