Analog Audio Connection ([IN] and [OUT] Connectors) (DME24N only)
The DME24N includes [IN] and [OUT] connectors for 8 channels of analog audio input and output. Wire
the supplied Euroblock plugs as shown below. Head amplifier gain and phantom power settings can be made
via the Utility display HA page described on page 54 of this manual, or via the DME Designer application.
Cable Preparation
Prepare cables to be attached to a Euroblock plug as shown below.
Be sure to use shielded cable.
CAUTION
Do not tin (plate with solder) the exposed sections of the cable.
WARNING
Euroblock Connection
N OT E
A slotted screwdriver with a blade width of about 3 millimeters is recommended.
1.
Loosen terminal screws.
2.
Insert cables.
3.
Securely tighten terminal screws.
Pull the cables (not too strongly) to confirm that they are securely connected.
4.
Plug the Euroblock plug into the panel connector.
Shielded Cable
7mm
30mm
Loosen.
Slotted Screwdriver
Terminal Screw
Euroblock Plug
3mm
+: Hot
-: Cold
G: GND
DME64N/24N Owner's Manual
Connection
35