Connecting To An External Device; Remote Connection ([Remote] Connector); Controlling External Head Amplifiers From The Dme64N/24N - Yamaha 1009MWTO-F0 Owner's Manual

Remote Connection ([REMOTE] Connector)

Connecting to an External Device

Remote Connection ([REMOTE] Connector)
The [REMOTE] connector of the DME64N/24N can be connected to remotely-controllable Yamaha AD8HR
or AD824 head amplifiers (pre-amps), digital mixers, or RS-232C compatible controllers (such as those from
AMX or Crestron). The [REMOTE] connector also transmits and receives MIDI messages.

Controlling external head amplifiers from the DME64N/24N

You can remotely control the AD8HR or AD824 head amplifier settings from DME Designer. Up to eight
AD8HR/AD824 head amplifiers can be connected.
When connecting to a combination of AD8HR and AD824 head amplifiers, be sure to place the AD8HR units
closest to the DME64N/24N in the chain, otherwise the AD8HR or AD824 unit(s) may not be properly rec-
ognized by the DME64N/24N. For details about the settings, refer to the "Ext HA Ctrl" in "Remote page" on
page 49.
Set to Remote
(422)
DME64N/24N
AD824
NOTE
Only control signals are transmitted and received via the REMOTE connection. Audio connections must be
made separately.
28 DME64N/DME24N Owner's Manual
D-SUB 9-pin Cable (Interlink Crossover)
REMOTE
AD8HR
COM PC/RS-422 COM RS-422
AD824
HA REMOTE 1 HA REMOTE 2
COM PC/RS-422 COM RS-422
HA REMOTE 1 HA REMOTE 2
AD8HR
COM PC/RS-422
AD824