Siemens SINUMERIK 840D sl Commissioning Manual page 281

6. Please enter here the user name and the password for the network drive that is to be
7. To restore user data only, enter the following command:
Scenario II: Start the Command Shell with WinSCP on the PG:
1. Start WinSCP and enter the following data in the log-on window:
2. Select in the menu "Commands" → "Open Terminal".
3. To restore the data, enter the corresponding commands as described under steps 3 to 5
See also
Connect (Page 27)
NCU Operating System (IM7)
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0
connected to.
To completely restore the system (system data and user data), enter the following:
sc restore –full backup01
Result: The whole system is overwritten by the backup data.
sc restore –user backup01
Result: The user data are written back again.
All subsystems are then restarted:
sc start all
Result:
The system state stored in the file "backup01" is restored on the NCU.
– IP address of the NCU (or, if required, host name)
– User name "manufact" with password "SUNRISE".
in scenario I.
Backing up and Restoring Data
2.3 Data backup on network drive
19