Yamaha CC-50 Owner's Manual page 35

RECORDING A COMPACT DISC
Receiver
CD Player
Tape Deck
4
TUNER DIRECT
1 2
1 2
6 7
6 7
A B
TIME PROG TAPE
5
REPEAT PRESET
DOWN
RANDOM PLAY
6
DECK REC/PAUSE
A/B
EFFECT LEVEL
+
-
POWER SLEEP DISPLAY
1
1
3 2
5
3 4 5
3 4 5
8
8 9 0
C D E
+
EDIT I0
STOP PLAY/PAUSE CD
1
A/B/C/D/E TUNER
UP
STOP PLAY TAPE
PHONO/AUX
DSP MODE SP/PHONES
VOLUME
- +
Automatic tape-editing
This convenient feature can be used to program tracks on a
disc for recording to tape. By only memorizing the tape's total
possible recording time, the unit will automatically program
tracks or help you to program tracks so they will fit onto the
tape with the least amount of unrecorded space remaining at
each end of the tape.
To record a disc with the order of tracks
unchanged
1
Select the CD player so that "CD" appears on the display
by pressing the INPUT selector
the disc to be recorded.
2
Load a tape into the cassette compartment.
3
When recording with the Dolby NR system, set the Dolby
NR switch to B or C; if not, set it to OFF.
* For selection of the Dolby B or C position, refer to the
"Dolby B and C Type Noise Reduction" on page 29.
4
Set the reverse mode switch to
5
Press the TAPE button to select the length of the tape to
be used. Whenever pressed, C-46, C-54, C-60 and C-90
appear on the display in turn, and next it returns to the
normal display mode.
off C-46
When using tapes other than C-46, C-54, C-60 or C-90
When C-46, C-54, C-60 or C-90 is appearing on the
display, input the tape length by using the track number
input buttons on the remote control transmitter
(Examples)
C-62: Press "6" and then "2".
C-30: Press "3" and then "0", or press "+10" three times
and then "0".
6
Press the EDIT button. ("EDIT" appears on the display.)
The following internal operations are carried out before
recording is automatically started.
1)Tracks on the disc are automatically divided between
side A and side B. You can check the process by
watching the display.
2)The end part of the tape on which recording cannot be
done is wound.
3)This unit starts searching for a peak level through all
tracks to be recorded. (While searching, "LEVEL"
flashes on the display.) When searching is finished, this
unit adjusts the recording level properly on the basis of
this data.
4)CD playback and recording starts. Recording is carried
out on both side A and B of the tape.
E-33
or button, and load
or .
C-54 C-60 C-90