Mitsubishi Electric FR-A800 Series Beginner's Manual page 30

Removal and reinstallation of the front cover
● Reinstallation of the front cover and the terminal block cover
Insert the upper hooks of the front cover into the sockets of the inverter.
Securely install the front cover to the inverter by fixing the hooks on the sides of the cover into
place.
Tighten the mounting screw(s) at the lower part of the front cover.
Fasten the terminal block cover with the mounting screws (The number of the mounting screws
differs by the capacity.).
NOTES Fully make sure that the front cover, and the terminal block cover are installed securely. Always
tighten the mounting screws of the front cover, and the terminal block cover.
The same serial number is printed on the capacity plate of the front cover and the rating plate of
the inverter. Before reinstalling each cover, check the serial numbers to ensure that the cover
removed is reinstalled to the inverter from where it was removed.
Removal and reinstallation (FR-A846 models)
● Removal of the front cover
Remove the front cover installation screws (hexalobular screws, screw size: M4, screwdriver size: T20)
to remove the front cover.
2 - 8
Loosen
Introduction to the inverters
Fasten
Fasten
Loosen