NOTE
• Fully make sure that the front cover has been reinstalled securely. Always tighten the installation screws of the front cover.
Removal of the wiring cover
• FR-E860-0040(2.2K) or lower
(a)
Screwdriver
Screwdriver
Screwdriver
(a)
Insert a tool such as a flathead screwdriver into the half-hole above the "PUSH" mark on the wiring cover to push the stopper behind the
wiring cover approx. 3 mm.
(b)
Pull out the cover along the guides in the direction shown by the arrow in the figure above.
• FR-E860-0061(3.7K) or higher
(a)
Screwdriver
Screwdriver
Screwdriver
(a)
Insert a tool such as a flathead screwdriver into the half-hole above the "PUSH" mark on the wiring cover to push the stopper behind the
wiring cover approx. 3 mm.
(b)
Pull out the cover along the guides in the direction shown by the arrow in the figure above.
Reinstallation of the wiring cover
• FR-E860-0040(2.2K) or lower
Fit the cover to the inverter along the guides, and push the hook into the socket.
• FR-E860-0061(3.7K) or higher
Fit the cover to the inverter along the guides.
26
2. Installation and Wiring
2.2 Removal and reinstallation of the front cover
Hook
Hook
(b)
(b)
Guides
Guides
Guides
Guides
Guides
Guides
Guides
Guides
Guides
Guides
Guides
Guides