GE AF-650 GP Design And Installation Manual page 107

RS-485 Installation and Set...
Coil Number
1-16
17-32
33-48
49-64
65
66-65536
Table 9.8
Coil 0
01 Preset reference LSB
02 Preset reference MSB
03 DC brake
04 Coast stop
05 Quick stop
06 Freeze freq.
07 Ramp stop
08 No reset
9 9
09 No jog
10 Ramp 1
11 Data not valid
12 Relay 1 off
13 Relay 2 off
14 Set up LSB
15 Set up MSB
16 No reversing
Adjustable frequency drive control word (drive profile)
Table 9.9
9-4
AF-650 GP
Description
Adjustable frequency drive control word (see table below)
Adjustable frequency driver speed or setpoint reference Range 0x0–0xFFFF
(-200% ... ~200%)
Adjustable frequency drive status word (see table below)
Open-loop mode: Adjustable frequency drive output frequency closed-loop
mode: Adjustable frequency drive feedback signal
Parameter write control (master to slave)
0 = Parameter changes are written to the RAM of the adjustable frequency
drive.
1 = Parameter changes are written to the RAM and EEPROM of the
adjustable frequency drive.
Reserved
1
No DC brake
No coast stop
No quick stop
No freeze freq.
Start
Reset
Jog
Ramp 2
Data valid
Relay 1 on
Relay 2 on
Reversing
TM
Design and Installation Guide
Coil 0
33 Control not ready
34 Adjustable frequency drive
not ready
35 Coasting stop
36 No alarm
37 Not used
38 Not used
39 Not used
40 No warning
41 Not at reference
42 Hand mode
43 Out of freq. range
44 Stopped
45 Not used
46 No voltage warning
47 Not in current limit
48 No thermal warning
Adjustable frequency drive status word (drive profile)
Table 9.10
DET-767A
Signal Direction
Master to slave
Master to slave
Slave to master
Slave to master
Master to slave
1
Control ready
Adjustable frequency drive
ready
Safety closed
Alarm
Not used
Not used
Not used
Warning
At reference
Auto mode
In frequency range
Running
Not used
Voltage warning
Current limit
Thermal warning