Advertisement
Quick Links
Side Mirror Kit
Workman
Model No. 119-9546
This product contains a chemical or chemicals known to the State of California to
Use
Installing the Side Mirror Kit (for Machines without a Canopy) (page 2)
canopy. Use
Installing the Side Mirror Kit (for Machines with a Canopy) (page 3)
discard unused components.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Upper mirror bracket
Lower mirror bracket
Mirror-mounting bracket
Bolt (5/16 x 3/4 inch)
Flange nut (5/16 inch)
Mirror
Screw (1/4 x 1 inch)
Nut insert
Mirror-mounting bracket
Bolt (5/16 x 1-1/2 inches)
Flange nut (5/16 inch)
Preparing the Machine
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key from the key switch.
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
MD/MDX/MDE Utility Vehicle
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Qty.
–
1
1
1
2
2
1
4
4
1
2
2
Register at www.Toro.com.
when installing the kit on machines without a
for machines with a canopy. You may
Prepare the machine.
Install the side mirror kit (without canopy).
Install the side mirror kit (with canopy).
Figure 1
Original Instructions (EN)
Form No. 3408-523 Rev A
Installation Instructions
Use
All Rights Reserved *3408-523* A
Printed in the USA
g038447
Advertisement
Related Manuals for Toro 119-9546
Summary of Contents for Toro 119-9546
- Page 1 Form No. 3408-523 Rev A Side Mirror Kit Workman ® MD/MDX/MDE Utility Vehicle Model No. 119-9546 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Installing the Side Mirror Kit (for Machines without a Canopy) 1. Measure 29 mm (1-1/8 inches) out from the edge of the dash on both the driver's and passenger's side (if installing a mirror on the passenger's side) and draw a G014831 parallel line to the edge (Figure...
- Page 3 Installing the Side Mirror Kit 9. Install a nut insert into each of the drilled holes (Figure (for Machines with a Canopy) 1. Locate the windshield-mounting holes in the front canopy-support tubes (Figure Note: The left canopy front-support tube is shown Figure G014834 g014834...
- Page 4 4. Secure the mirror mounting bracket to the tube with 2 bolts (5/16 x 1-1/2 inches) and flange nuts (5/16 inch) as shown in Figure G014838 g014838 Figure 10 1. Mirror-mounting bracket 3. Flange nut (5/16 inch) 2. Bolt (5/16 x 1-1/2 inches) 5.