Table of Contents
Advertisement
3.
Loosely install a brace bracket to each brace
with a bolt (1/2 x 2-1/2 inches), washer (1/2
inch), and flange nut (1/2 inch) as shown in
Figure
35.
4.
Position the ROPS-mounting brackets onto
the top of the traction unit roll bar
Make sure that the roll bar is centered in the
ROPS-mounting brackets.
Figure 36
1. ROPS-mounting bracket
2. Roll bar post
3. U-bolt (4 inches)
5.
Using the mounting holes shown in
mount each ROPS-mounting brackets to the top
of the roll bar with 2 U-bolts (2-3/4 inch) and 4
flange nuts.
6.
Using the mounting holes shown in
loosely secure each of the brace brackets to
the roll bar posts with a U-bolt (4 inches) and
2 flange nuts.
7.
Move the brace bracket up or down, on the
vertical roll bar posts, until the sunshade frame
is level to the floor.
Note:
Use a level to make sure that the frame
is level to the ground.
Note:
Use the front or rear mounting holes in
the brace bracket, if you need more adjustability.
8.
Tighten the U-bolt flange nuts, securing the
mounting brackets to the posts
9.
Tighten all the remaining flange nuts as follows:
•
Torque the flange nuts (3/8 inch) 41 to 55
N∙m (34 to 41 ft-lb).
•
Torque the flange nuts (1/2 inch) 113 to 141
N∙m (84 to 104 ft-lb).
(Figure
36).
g212622
4. Flange nut (3/8 inch)
5. U-bolt (2-3/4 inch)
Figure
36,
Figure
36,
10.
Remove the flange-head bolts securing the
frame-alignment bar to the frame and remove
the alignment bar. Retain the bolts for mounting
the sunshade.
11.
While aligning the mounting holes, position the
sunshade onto the frame as shown in
1. Flange-head bolt (5/16 x
1-1/4 inches)
2. Small washer
12.
Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 1-1/4
inches) and 2 small washers and a spacer
(Figure
37). Position a washer on each side of
the sunshade-rubber grommet.
13.
Tighten the sunshade-mounting bolts to 5 to 6
N∙m (45 to 55 in-lb).
Important:
Do not overtighten the mounting
bolts as the sunshade may crack.
19
Figure
Figure 37
3. Sunshade
4. Spacer
37.
g021308
Advertisement
Table of Contents
