Figure 12
1. Pin
2. Hairpin cotter
3.
Insert a washer (13/16 x 1-1/2 inches) onto each
bolt (3/4 x 4 inches) as shown in
Figure 13
1. Nut (3/4 inch)
2. Roll bar
4.
In the holes where the pins were removed,
install the bolts and washers
5.
Install another washer onto each bolt and
secure with nuts (3/4 inch) as shown in
13. Torque the nuts 323 to 396 N∙m (238 to 292
ft-lb).
g187726
3. Roll bar (raised position)
4. Roll bar (lowered position)
Figure
13.
g018099
3. Washer (13/16 x 1-1/2
inches)
4. Bolt (3/4 x 4 inches)
(Figure
13).
Figure
6.
Torque the ROPS pivot bolt
113 N∙m (67 to 83 ft-lb) to avoid any bouncing of
the roll bar and sunshade.
7.
On each side of the sunshade frame, loosely
mount a brace to the second hole of the brace
bracket with a bolt (1/2 x 2-1/2 inches), washer
(1/2 inch), and flange nut (1/2 inch) as shown
in
Figure
14.
1. Bolt (1/2 x 2-1/2 inches)
2. Washer (1/2 inch)
3. Brace
4. Front hole
5. Flange nut (1/2 inch)
8.
Loosely install a brace bracket to each brace
with a bolt (1/2 x 2-1/2 inches), washer (1/2
inch), and flange nut (1/2 inch) as shown in
Figure
14.
9.
Position the ROPS-mounting brackets onto the
top of the traction unit roll bar
Note:
Make sure that the roll bar is centered in
the ROPS-mounting brackets.
1. ROPS-mounting bracket
2. Roll bar post
10.
Using the mounting holes shown in
mount each bracket to the top of the roll bar with
2 U-bolts (2-3/4 inch) and 4 flange nuts.
10
(Figure
13) 91 to
Figure 14
6. Second hole
7. Third hole
8. Rear hole
9. Brace bracket
(Figure
15).
Figure 15
3. U-bolt (2-3/4 inch)
4. Flange nut (3/8 inch)
Figure
g020026
g019765
15,