Table of Contents
Advertisement
11.
Using the mounting holes shown in
loosely secure each of the brace brackets to
the roll bar posts with a U-bolt (2-3/4 inch) and
2 flange nuts.
12.
Move the brace bracket up or down, on the
vertical roll bar posts, until the sunshade frame
is level to the floor. Use a level to make sure that
the frame is level to the ground. Then, tighten
the U-bolt flange nuts, securing the mounting
brackets to the posts.
Note:
Use the front or rear mounting holes,
in the brace bracket, if more adjustability is
required.
13.
Tighten all the remaining flange nuts as follows:
•
Torque the flange nuts (3/8 inch) 41 to 55
N∙m (34 to 41 ft-lb).
•
Torque the flange nuts (1/2 inch) 113 to 141
N∙m (84 to 104 ft-lb).
14.
Remove the flange-head bolts securing the
frame-alignment bar to the frame and remove
the alignment bar. Retain the bolts for mounting
the sunshade.
15.
While aligning the mounting holes, position the
sunshade onto the frame as shown in
1. Flange-head bolt (5/16 x
1-1/4 inches)
2. Small washer
16.
Loosely mount each corner of the sunshade
to the frame with a flange-head bolt (5/16 x
Figure
Figure
Figure 16
3. Sunshade
15,
1-1/4 inches) and 2 small washers
Position a washer on each side of the sunshade
rubber grommet.
17.
Tighten the sunshade-mounting bolts 5 to 6 N∙m
(45 to 55 in-lb).
Important:
bolts as the sunshade may crack.
16.
g020027
11
Do not overtighten the mounting
(Figure
16).
Advertisement
Table of Contents
