Husqvarna HUV 4214 2009 Maintenance And Service Manual page 53

ACCELERATOR AND BRAKE PEDAL GROUP
1
1. Locking Pin 2. Bed Locking Pin Holes
K-00221
Figure 5-11 Bed Locking Pin
5. Detach accelerator cable extension spring(s) (Figure 5-13, Page 5-5). See following NOTE.
NOTE: Later models have a second spring attached to a unique cable end bolt that is taller and grooved.
6. Loosen cable clamp that secures accelerator cable (Figure 5-14, Page 5-5). This will allow additional travel so
that the cable can be disconnected at pedal.
982
Figure 5-13 Detach Accelerator Cable Extension Spring(s)
(later models have a second spring attached to tall cable
end bolt)
7. Remove the bolt securing the cable end to the bellcrank (Figure 5-15, Page 5-6).
8. Under the front cowl, disconnect the Z-shaped end of the accelerator cable from the pedal (Figure 5-16,
Page 5-6).
9. Compress the tines of the cable anchor and pull the cable from the mounting bracket.
10. If equipped, note location and number of wire ties securing cable to chassis. Cut wire ties and remove cable.
2009-2010 HUV 4214, HUV 4414, and HUV 4414X Maintenance and Service Manual
2
Accelerator Cable Removal
1023
Figure 5-12 Remove Exhaust Heat Shield
983
Figure 5-14 Loosen Cable Clamp
5
Page 5-5