Side Panel Installation; Under Seat Center Panel; Under Seat Center Panel Removal - Husqvarna HUV 4214 2009 Maintenance And Service Manual

4

Under Seat Center Panel

3. Remove ROPS. See ROPS Removal on page 4-16.
1159
Figure 4-33 Side Panel Removal
4. Remove the hardware securing the cargo bed rubber bumper. Remove the bumper to release the side panel
support bracket (Figure 4-33, Page 4-20).
5. Remove side panel from vehicle.

SIDE PANEL INSTALLATION

1. Install side panel in the reverse order of removal.
2. Tighten side panel bolts to 22 in-lb (2.5 N·m). Tighten cargo bed rubber bumper bolts to 84 in-lb (9.5 N·m).
3. Install ROPS. See ROPS Installation on page 4-18.
UNDER SEAT CENTER PANEL
See General Warning on page 1-2.

UNDER SEAT CENTER PANEL REMOVAL

1. Remove seat bottom from vehicle.
2. Remove bolts from under seat center panel (Figure 4-34, Page 4-21).
3. Remove center panel from vehicle (Figure 4-35, Page 4-21).
Page 4-20 2009-2010 HUV 4214, HUV 4414, and HUV 4414X Maintenance and Service Manual
BODY AND TRIM